 |
- Remove the fuse panel cover.
- On my '97 A4 and '00 S4, the 4th fuse location is empty and is switched with the
ignition.
- Attach a spade connector that is the same size as a normal fuse to the positive (+) wire
of the V1 module .
- Insert it into the left [ - - ] side of the fuse slot. This slot location
only has a connector on the left side.
|
 |
- The V1 hardwire module comes with an inline fuse holder. Be sure to use it!
- Attach the ground wire. I chose the one of the bolts for the dash.
- Secure the supplied RJ-11 hardwire module and all the wiring after you've finished
routed the wiring.
|
 |
- Take look at the very cool dashboard energy absorbing structure. Elegantly
crafted aluminum honeycomb.
|
 |
- My V1 is mounted on the sun visor. If you mount yours on the windshield run the
cable along the base of the windshield or whatever you prefer.
- I ran the RJ11 cable between the dash and up the A-pillar. I applied a very
small amount of clear silicone on the cable in 4 locations to secure it. The black
cable is almost invisible once it's tucked in.
|
 |
|
 |
- Bad picture but you get the idea.
|
